Is SLES safe? Yes, when used as intended. Sodium laureth sulfate is a skin and eye irritant at high concentration but not a sensitiser, and the Cosmetic Ingredient Review found it safe in cosmetics formulated to be non-irritating. The main quality issue is 1,4-dioxane, a trace by-product of ethoxylation that producers remove and buyers should limit in their specification.
Sodium laureth sulfate (SLES) is one of the most widely used surfactants in shampoos, body washes and household cleaners. Its safety questions come down to three points: irritation at high concentration, traces of 1,4-dioxane from ethoxylation, and handling of the concentrated raw material.
Is SLES Harmful?
- Irritation, not sensitisation: the Cosmetic Ingredient Review (CIR) found sodium laureth sulfate to be an irritant but not a sensitiser, and safe in cosmetics when formulated to be non-irritating (Int. J. Toxicol. 2010; 29(4 Suppl):151S–161S).
- Concentration matters: the 70% raw material is far more irritating than a finished shampoo, where SLES is diluted and combined with milder co-surfactants.
- Rinse-off use: most SLES products are rinsed off, which keeps contact time short.
1,4-Dioxane: What It Is and How It Is Controlled
1,4-Dioxane can form in small amounts during ethoxylation. IARC classifies it as Group 2B (possibly carcinogenic to humans). Producers reduce it by process control and vacuum stripping. It is not an ingredient; it is a trace by-product, so it must be controlled through the specification.
Regulatory Limits
| Jurisdiction | Rule |
|---|---|
| New York State (USA) | Household cleansing and personal care products: 2 ppm from 31 Dec 2022, 1 ppm from 31 Dec 2023. Cosmetics: 10 ppm from 31 Dec 2022. Put into regulation (6 NYCRR Part 352) in 2024. |
| European Union | 1,4-Dioxane is a prohibited substance in cosmetics (Regulation (EC) No 1223/2009, Annex II); technically unavoidable traces are allowed only if the product remains safe (Article 17). |
How Buyers Should Specify Dioxane
- Add a 1,4-dioxane limit to the purchase specification, sized for your finished-product limit and dilution.
- Name the test method (headspace GC-MS is common).
- Ask for the result on each lot COA.
- Our SLES TDS does not list 1,4-dioxane; request it on the COA if your market needs it.
What “Low-Dioxane” and “Dioxane-Free” SLES Mean
All SLES is made by ethoxylation, so 1,4-dioxane can form in every grade; what differs is how much is left after stripping. Suppliers therefore sell grades with a stated maximum 1,4-dioxane content:
- Low-dioxane SLES: produced with tighter process control and vacuum stripping, sold with a guaranteed ppm limit suited to strict markets.
- “Dioxane-free” SLES: a marketing term that should mean “below the detection limit of a named test method”. Ask for the method and its detection limit; without them the claim cannot be checked.
- How to choose a limit: work back from your finished-product limit (for example 1 ppm in New York household and personal care products) and the SLES level in your formula, then add a safety margin.
Side Effects of SLES
| Effect | When it happens | How it is avoided |
|---|---|---|
| Skin dryness or irritation | High concentration, long contact, sensitive or damaged skin | Moderate SLES level, amphoteric co-surfactant, skin-compatible pH |
| Eye irritation | Splashes of product or raw material | Rinse with water; use eye protection when handling concentrate |
| Irritation from the raw material | Handling 70% paste without protection | Gloves and goggles; follow the SDS |
SLES is not classified as a carcinogen; the cancer concern is about 1,4-dioxane traces, which is why they are limited.
Handling the Raw Material
- Avoid contact with skin and eyes; refer to the SDS.
- Store in a cool, dry place away from heat; avoid repeated freeze/thaw cycles.
- Dilute the 70% grade slowly under gentle mixing to avoid gel formation.
Environment
Our SLES TDS describes the product as readily biodegradable. Concentrated SLES should not be released to drains or surface water; send process water to treatment.
Our SLES Grades
| Parameter | SLES 70% (GAC-SLES-70) | SLES 30% (GAC-SLES-30) |
|---|---|---|
| Appearance | Pale yellow to amber liquid | Pale yellow to amber liquid |
| Active matter | 70 – 75% | 25 – 30% |
| pH (10% solution) | 6.5 – 8.5 | 6.5 – 8.5 |
| Ionic character | Anionic | Anionic |
| Solubility | Soluble in water; insoluble in oils and most organic solvents | Same |
| INCI name | Sodium Laureth Sulfate | Sodium Laureth Sulfate |
| Packing | Drums (200 – 220 kg); IBC and bulk on request | Drums and bulk containers |
Related: SLES vs SLS, SLES mildness.
Frequently Asked Questions
Is SLES harmful?
SLES is an irritant at high concentration but not a sensitiser; CIR found it safe in cosmetics when formulated to be non-irritating.
What is the 1,4-dioxane limit for SLES products in New York?
1 ppm in household cleansing and personal care products from 31 December 2023, and 10 ppm in cosmetics.
Is 1,4-dioxane allowed in EU cosmetics?
It is a prohibited substance; only technically unavoidable traces are allowed if the product is safe.
What are the side effects of SLES?
Skin and eye irritation, mainly at high concentration or with long contact.
Is SLES biodegradable?
Our SLES TDS describes it as readily biodegradable.
What is dioxane-free SLES?
SLES whose 1,4-dioxane content is below the detection limit of a stated test method. Ask the supplier for the method and detection limit, and for the result on each COA.
What is the 1,4-dioxane limit in the EU?
1,4-Dioxane is prohibited in EU cosmetics; only technically unavoidable traces are tolerated if the product remains safe. There is no single numeric limit, so buyers set one in their specification.
Can SLES cause cancer?
SLES itself is not classified as a carcinogen. The concern is traces of 1,4-dioxane (IARC Group 2B), which producers remove and markets limit.















